10-21-2011 07:50 AM
Hi
On RV016 router WAN port 1 is showing Half duplex wen i check it in Port setup but when i check it on Port status its showing me as Half duplex, how can we
force it to make it full duplex.
10-21-2011 11:04 AM
I took a look at my RV082 and my wan port is also half duplex but I have auto negotiation enabled so I am assuming that my wan router can only support half duplex. Are you sure the device you are plugging into your wan port can support full duplex?
-Adam
10-24-2011 06:17 AM
Hi Adam
Thanks for your reply but i was able to figure it out and make it Full duplex.
I just disable the Auto-negotiate and then forced it to be Full duplex mode and then it was showing as Full duplex.
Pragnesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide