RV042 IPSec VPN - Shrew Client

[berserkpi]

Ok this is my problem.

Thanks to this discussion (https://supportforums.cisco.com/thread/2022824) I know that Windows does not have an IPSec client. So I decided to use Shrew.

As the discussion stated I set up a "Client to Gateway" as a Group using "Microsoft XP/2000 VPN  Client" for the remote client. Given this, what should I select in "VPN site configuration"->Authentication->Local Identity sub tab inside Shrew 2.1.7? Shrew gives 4 options:

Fully Qualified Domain Name

User Fully Qualified Domain Name

IP Address

Key Identifier

Thank u very much.

[greenpoise]

did you ever figure this one out??? I would like to use shrew but tried different settings with no success..

[Te-Kai Liu]

Please try this link, which contains step-by-step instructions.

https://supportforums.cisco.com/docs/DOC-10266