Routers - Small Business

Hi. I have an RVS4000 with firmware V2.0.0.3 .I have set up 2 VLAN on with ip 192.168.1.1 and one with ip 192.168.1.1 . The VLAN's is not working properly, i can ping between them. Any idea's?

I am trying to configure my wireless router at home which is a WRV200 Wireless-G VPN Routher to connect to my firewall at work which hosts my voicemail system.I am not sure how to configure the router to automatically vpn to my work location so that ...

Hi,I have a WRV200 and need to setup a wifi access for a place that is shared. So two questions:1. How can I have two SSIDs, one for me, one for visitors with my router? Is it by setting up a VLAN ? If yes, would those persons be able to access the I...

Where can I buy AC adaptor for RV-042? I use 4 of this router but 2 of these AC adaptor went bad. Can I buy AC adaptor only instead buying whole unit?Kiyoshi

hi,rv042 after configuring dhcp is giving to clients dns with appended  suffixhow can I take out append dns suffix? because when I ping server, for  example, inside lan, automatically transform in server.mydomain.com and return  error, of cours....ho...

I bought a couple of these to trial for location to remote telemedicine sites.  However I am only able to route one network range over the IPSec VPN.  I have to route multiple network ranges, and I am not able to make any modifications to the static ...

Hi,I've just bought a couple of WRV210 routers to use at a couple of home offices. They connect into the RV042 in our office fine. However, with both of them we seem to be unable to connect the LAN ports to standard switches, an NAS device and a powe...

I have approx. 26 wired users connecting to a Cisco WRVS4400N through switches so there is only one connection to the Cisco WRVS4400N for Internet access. I am also running two wireless SSID's. Is this to much for this router to handle? It takes spel...

I received a Cisco AP541N dual band wireless access point with instructions explaining the device should be contacted via http://192.168.10.10. The device was actually listening on 192.168.72.102. Has anyone else noticed this?

I have brand new router RV220W E V01 (E-K9-G5) model for Europe. During configuration of the router I found the following 3 issues:Time setting:Time setting is OK for GMT with or without Daylight Saving TimeTime setting is OK for CET without Daylight...

Currently I have a VPN tunnel setup between our company locations. Location A has Linksys RV016 and Location B has RV082.  Everything has been working with no problems for the past 2 years with only minor disconnect issues in the VPN tunnel between t...

Ok this is my problem.Thanks to this discussion (https://supportforums.cisco.com/thread/2022824) I know that Windows does not have an IPSec client. So I decided to use Shrew.As the discussion stated I set up a "Client to Gateway" as a Group using "Mi...

I have  a new RVS4000 router, which is hosing a seagate GoFlec Home drive.Origianally my WRT54G router worked fine.I cannot get the UPnP to work.I have UPnP enabled.I have my goFlex Home to automatically configure router for portforwarding, ports 21,...

I bought a new RV220W router recently. We have a network storage NAS 200 in our office that should be reached by 5-6 remote clients through the Internet (partly from behind simple routers having no VPN facility, partly from mobile network). I had sol...