RV042 please help how to direct traffic through specific wan port?

[John Clausen]

I have an RV042. I understand and have created the services I need. The documentation is just not clear on how to direct traffic for these services to a specific wan port.

Can this even be done with this router? If so, the how? Use rate control or priority? Does checking a wan port mean that it will only go through that port?

Thank you,

John

[Te-Kai Liu]

You could bind service along with IP range to a given WAN interface at System Management>Dual WAN under the Protocol Binding section.

[thomsen47]

On our RV042 (3) FW 4.2.1 this menu does not appear...

no matter if SmartLink oder LoadBalance is selected.

[Te-Kai Liu]

Click on the "Configure" icon to see the settings.

[thomsen47]

Uuh..stupid question

Thanks!