04-21-2013 07:28 AM
Hello,
I have a Cisco RV215W and i want to create inbound rule (wan -> lan) with ip control.
I ha created in "service management" a new service (rsync on 873 start port and and port)
After i had created a new access rules :
Action : Always Allow
Service : Rsync ( a service created in service management)
Status : enable
Connection type : inbound (Wan -> Lan)
source ip : single ip with outdoor serveur
Destination ip : ip to NAS
When i connected on outdoor server, i used telnet :
telnet my_public_ip 873 and i cannot connect my NAS
when i create a rule in "single port forwarding", my outdoor server can access on my NAS (but all outdoor customer can access on my NAS....)
Do you have an idea?
thank a lot per advance
04-23-2013 01:07 PM
Hi Bruno, thank you for using our forum, my name is Johnnatan I am part of the Small business Support community. You could create an ACL to allow the specific address to the NAS and deny the rest.
Bellow I will share a Link with a document regarding ACL,
http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=3707
http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=3707I hope you find this answer useful
“Please rate useful posts so other users can benefit from it”
Greetings,
Johnnatan Rodriguez Miranda.
Cisco Network Support Engineer.
04-23-2013 03:16 PM
Hello Jonathan,
Thank's a lot for your response.
I have read your link and my configuration it was same your link except a rule to deny the rest.
but when i try a connection i receive an error :
it's very strange...
If i put my NAS in dmz all is ok...
And my firmware is a 1.1.0.5
Best regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide