to whom it may concern,
Just purchased RV320 to replace ISR 1800. I have a hard time setting up port forwarding to allow RDP and Plex ports to be opened. Following Cisco guidelines and google search did not help. Below is the settings currently configured
Port Range Forwarding Table
| PLEXTV[TCP/32400~32401] | 192.168.1.252 | Enabled |
Port Address Translation Table
| PLEXTV[TCP/32400~32401] | 192.168.1.252 | Enabled |
IP/MAC Binding
| 192.168.1.252 | zx:3t:cv:26:F2:rx | ReadyNAS | Enabled |
Access Rule
| Allow | PLEXTV [32400] | WAN1 | Any | Any | Always |
