Goal:
Expose multiple machines to public IPs via RV340 by static NAT of public IPs to private IPs.
Current (not working) setup
Internet provider side:
| MAC address | Public IP address |
| 00:0C:26:B6:65:D8 | 146.10.23.23 |
| 00:0C:26:B6:65:D8 | 146.10.123.123 |
| 00:0C:26:B6:65:D8 | 146.10.223.223 |
| 00:0C:26:B6:65:D8 | 146.10.323.323 |
Note: all static IPs are mapped to the same WAN1 MAC address of the router.
RV340 has four WAN port (2xUTP; 2xUSB), however my internet provider connects only one cable to WAN1(UTP) and provides me with 5 random static IP addresses.
Static NAT GUI setup with random public IPs (can't be in a range)
| Private IP range begin | Public IP range begin | Range Length | Service | Interface |
| 192.168.1.10 | 146.10.23.23 | 1 | All trafic | WAN1 |
| 192.168.1.20 | 146.10.123.123 | 1 | All trafic | WAN1 |
| 192.168.1.30 | 146.10.223.223 | 1 | All trafic | WAN1 |
| 192.168.1.40 | 146.10.323.323 | 1 | All trafic | WAN1 |
Only the IP used in the WAN settings (GUI) works and the rest of them are useless regardless of the static NAT settings.
Can someone provide me with guidance on a way (probably via SSH access to the router) to setup different virtual MAC addresses on a single WAN interface if that possible at all on the router? I guess this will enable all public IPs to work against the static NAT properly.
I am open for any other suggestion which reaches the goal above.
Thank you
