Hi All,
I am trying to configure a SA 520 device.
Hi all,
I am trying to configure an SA520 for WAN access,but i noticed the config i applied on the WAN does not appear on the WAN status page.It only tells me the Link Status is up meaning i inserted a cable,but the config does not appear on the WAN status page.
Connection Time | : Not Yet Available |
Connection Type | : STATIC |
Connection State | : Not Yet Connected |
Link State | : LINK UP |
WAN State | : DOWN |
IP Address | : 0.0.0.0 |
Subnet Mask | : 0.0.0.0 |
Gateway | : 0.0.0.0 |
DNS Server | : 0.0.0.0 |
I also would like to know how to configure an outbound rule from LAN to WAN on the static route page.All i tried did not work
I have a LAN address 192.168.1.0/24
GW:192.168.1.1
WAN IP:77.77.77.1/28
GW:77.77.77.1
WAN interface on SA:77.77.77.2
Can someone tell me how to apply this on the Static route page
Thanks