Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am having a challenge on an AP3802 not joining the WLC.The WLC runs on version 8.3.143.0, while the version of the AP is 8.2.151.0. All other APs have connected, though this AP was used to replace a bad AP, as it was not with the other APs ...
Hi All,I want to know if the Cisco 2900 series can do UC without having to buy any other hardware.I read through the 2900 series datasheet, and i can understand it does.But will want to clarify if i do not need any other hardware except the Unified C...
Hi All,Just wanted to know if the small business WAP 4410N access point can work with a UC520 router? I presently use the 521 models but will want to use another model/type.
Hi All,I have an ASA 5510 which i've configured for internet access.I can connect to the internet from the ASA box,I can ping public networks from the console of the ASA box,but cannot access public hosts from internal hosts connecting via the ASA bo...
Hi All,I am trying to configure a SA 520 device.Hi all, I am trying to configure an SA520 for WAN access,but i noticed the config i applied on the WAN does not appear on the WAN status page.It only tells me the Link Status is up meaning i inserted a...
Hi l-carvalho ,CDP does not show any result as it was discovered that its not even shown as connected on the switch interface. I had to RMA the device,as someone else mentioned in this forum that it has to do with the software image on that particula...
Hi,Thanks for the input.ASA version 8.3(1) does not support global commands anymore. So i had to stay with my nat command.Your advice on the removal of the access-lists worked. I had to remove the INSIDE acces-lists but left the acls for icmp so that...
Hi Julio,I have applied the configs you posted, but unfortunately clients on the inside cant still get to the outside.Inside hosts can ping the outside gateway but cant go beyond that.I'll appreciate more input or idea as regards this.Thanks for your...
Hi.Thanks for the reply.I had to reconfigure the device,but still no headway.Maybe we can work with this new config.The config is pasted below.I intend natting my internal(Trust) address which is on the 10.22.x.x network to the 192.168.22.x(vpnout) n...
