02-20-2013 03:20 PM
RV042G V01 Firmware v4.2.1.02 (Jan 18 2012 14:10:55) running IPv4 mode only. There is an active DynDNS account running on WAN2.
I have got a problem with the RV042G because bank and public security systems "nemID" actually can see my two IP's and therefore "thinks" I am fifling with the connection.
Anyway the result is that I am thrown off the connection. Anybody have any ideas?
Thanks in advance Bo.
Solved! Go to Solution.
02-21-2013 01:50 PM
To set up protocol binding do the following
Lastly, test to see if it works. You can either go to the page your trying to access or you may go to a external website such as www.ipchicken.com and keep refreshing to see if your Ip changes.
-Tom
Please mark answered for helpful posts
02-20-2013 05:03 PM
Hi Bo, if you're running both WAN ports simultaneously, it means you are load balancing. There are 2 solutions for this.
-Tom
Please mark answered for helpful posts
02-21-2013 01:49 PM
Hi Tom, Thank You for a very quick answer, but I have a problem I can't figure out how to "Bind the protocol to a particular WAN port for specific machines while using the load balancing mechanism".
Could you explain it further?
Thank you in advance Bo.
02-21-2013 01:50 PM
To set up protocol binding do the following
Lastly, test to see if it works. You can either go to the page your trying to access or you may go to a external website such as www.ipchicken.com and keep refreshing to see if your Ip changes.
-Tom
Please mark answered for helpful posts
03-04-2013 07:38 AM
It works Thank you very much. You are a genius
After Your first answer I had figured out everything but the destination IP.
( I have been to France (Val Thorens) skiing last week therefore the late reply)
Once more tank you verey much for a very good and competent answer.
Bo Steffensen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide