02-28-2011 11:32 PM - edited 03-04-2019 11:36 AM
Hello!
I have the following situation:
I have 4 1841 routers configured for load balancing and failover:
net 1
|
router1 ------------------- router10
| |
| |
| |
router2 ------------------- router11
|
net 2
I want to configure the ospf to make load sharing over both connections. How does the configuration look?
Regards,
Andreas
03-01-2011 12:45 AM
Hi Andreas,
You can use equal cost for loadsharing or use unequal cost for failover config.
for example;
interface fastethernet0/0
ip ospf cost 3000
hth
Muammer
03-01-2011 03:46 AM
I know this, but I want to know how i configure the routes from net 1 and net 2 over the
"router ospf" command.
thanks
Regards
Andreas
03-01-2011 04:28 AM
Hi,
You can put all interfaces in same area, eg network 0.0.0.0 255.255.255.255 a 0
or you can put specific interfaces with eg network 192.168.10.1 0.0.0.0 a 0 192.168.10.1 being ip address of interface
you can also do the same under interface instead of routing process with command ip ospf a 0
Where are net1 and net2, what is there between your routers? ethernet with switches, serial links?
Regards.
Alain.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide