04-06-2011 05:53 AM - edited 03-04-2019 11:59 AM
Hi,
I'm trying to configure my BRI interface in "network protocol-emulate network" and "layer1-emulate network" but i don't have this second command.
Is someone have allready to that with this type of interface ?
I've to configure this because the ISDN line of my telco is in user mode only.
CISCO 1841
IOS C1841-IPBASE-M
12.4(15)T12
WIC-1B-S/T-V3
Thanks
04-13-2011 01:51 AM
Could you please apply below command,
Router(config-if)# isdn protocol-emulate {user | network} ! Since you are using for user , enter user.
Please rate the post if it helps.
Regards,
Jyoti
04-13-2011 05:37 AM
I can enter this command :
Router(config-if)# isdn protocol-emulate NETWORK
But it's only for the layers 2&3. My problem is with the layer 1.
I've tried to make a crossover cable but it doesn't work.
I've see in me research on the web that there was the command :
Router(config-if)# layer1-emulate network
but i think that it's only for VIC inerfaces and i've a WIC.
04-13-2011 03:04 AM
What are you trying to do? That card does NOT support voice.
04-13-2011 05:38 AM
It's to make a little WAN between to site and noly for DATA, not for voice.
04-14-2011 04:42 AM
And what would the architecure of the "little WAN" ?
Seems to be there is no practical use.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: