2621 class-map for VoIP

[gyalch]

I am setting up QoS on our 2621s and need to setup a class-map to match traffic from either an ethernet interface on the router or hopped traffic with a specific source address. I have created an access-list for the source address but have run into a problem with the class map. I am trying to setup

class-map match-any MyClass

match input-interface ethernet1/0

match access-group 101

The problem is that when I try to enter this, the match-any or match-all commands don't seem to be available. It will only let me enter a class-map name and then one criteria. I am running 12.1(3a) with Plus. I'm not sure what I'm missing but any help would be great. Thanks.

[peterson.dave]

I would upgrade your level of code.

[gyalch]

Thanks for your response. That brings about another question then is how do I go about obtaining a code update. I have never been able to find information about upgrading a software image and what is involved there. Thanks.

[peterson.dave]

Your smartnet agreement should allow you to download a new image, which you can find in the IOS download center.

Then use the copy tftp flash command