2811 can it support BRI and PRI cards at the same time

[robert.jubb]

I wish to use a VWIC2-2MFT-T1/E1 and a VIC2-2BRI-NT/TE in a 2811 -can they co -operate at the same time - ??????

[paolo bevilacqua]

Yes.

[bradvanner]

http://www.cisco.com/en/US/docs/routers/access/interfaces/ic/hardware/installation/guide/inst_ic.html

A note amongst the installation instructions states the following: Do not install an ISDN BRI WAN interface card or an ISDN BRI network module in the same chassis as an ISDN PRI network module.

[paolo bevilacqua]

bradvanner wrote:
 http://www.cisco.com/en/US/docs/routers/access/interfaces/ic/hardware/installation/guide/inst_ic.html
A note amongst the installation instructions states the following: Do not install an ISDN BRI WAN interface card or an ISDN BRI network module in the same chassis as an ISDN PRI network module.

That is incorrect, as it is a supported configuration, and it works just fine.

In these case you can use the feedback form on the left for the documenation to be fixed.,