2900 Router and NM-HDV2-2T1/E1

fgasimzade · ‎03-09-2011

Hello everybody!

Here:

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet09186a00800921e7_ps2797_Products_Data_Sheet.html

is mentioned that NM-HDV2-2T1/E1 is supported on 2921 2951, but I was unable to find Network Module slots on 2921 and 2951 pictures.

Can anyone confirm, that these network slots are supported?

This is where I saw pictures

http://www.gocomsys.com/assets/galleries/481/2921b.jpg

Thank you in advance!

Akula Jyoti Lakshmi · ‎03-09-2011

Hello,

You can install the card on main slot of chassis ,

r1#show inventory 
NAME: "c2921 chassis", DESCR: "c2921 chassis"
PID: CISCO2921       , VID: N/A , SN: FHH1230P06U

NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 4", DESCR: "PVDMII DSP SIMM with four DSPs"
PID: PVDM2-64          , VID: V01 , SN: FOC11526ZQ0

NAME: "High Density Voice2 Network module with on board two port interface  on Slot 1", DESCR: "High Density Voice2 Network module with on board two port interface "
PID: NM-HDV2-2T1/E1    , VID: V04 , SN: FOC12245B5M

Hope it helps,

Jyoti

uldericonucci · ‎09-02-2014

Hi,

the NM-HDV2-2T1/E1 is supported by 2921 and 2951, but you need an adapter between SM and NM. The part to order is:

SM-NM-ADPTR

Hope this help,

Regards,

Ulderico