11-14-2012 09:03 PM - edited 03-04-2019 06:08 PM
I just recently upgraded my 3845 to 15.0.1M9 and everything was going fine until I turned it back on later today. It is now stuck in a loop and wont even allow me to access ROMMON. I took out all additional hardware and it is still stuck at this screen
System Bootstrap, Version 12.3(11r)T2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2005 by cisco Systems, Inc.
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
Corrected ECC from L2 cache or memory: 0xc0dc0000
0x00100208A0 = 0x55555555
0x00100208A8 = 0xaaaaaaaa
0x00100208B0 = 0x55555555
0x00100208B8 = 0xaaaaaaaa
0x00100208C0 = 0x00000000
0x00100208C8 = 0x000000ff
CPO_ECC (reg 26/0): 0x00000000
CPO_ECC (reg 26/1): 0x10a20000
CPO_CACHERI (reg 27/0): 0x24000aa0
CPO_CACHERD (reg 27/1): 0x00000da0
CPO_CCHEDPA (reg 27/3): 0x0000cda0
Any Idea's on what this is or how to fix it?
V/r
Josh
11-14-2012 10:13 PM
I have fixed the issue. I took out the system board and reseated the RAM module and put all of the hardware back in place. It booted with no issues after that.
V/r
Josh
11-14-2012 10:39 PM
Good finding Joshua,
Regards
Thanveer
"Everybody is genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is a stupid."
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide