Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone done a direct SIP Integration from Cisco Unity Connection to Avaya System Manager? I setup the phone system and ports/port groups but when trying to call in from Avaya I keep getting a 400 Bad Request 'Invalid SDP Information' on the Avaya...
Has anyone navigated this bug and successfully upgraded their CIMC? Is a CIMC upgrade needed to upgrade ESXi, we are currently at 6.0 but want to upgrade to 6.7 u3. Our CIMC is currently at 3.0{4a).
Hello, I just upgraded a customer's Call Manager Cluster from 11.5 SU2 to 11.5 SU6 and they are now experiencing this issue. So far two sites have reported that calls are being sent to the overflow number even though agents are available, the queue i...
Hello,
I am having trouble figuring out why my outbound calling is not working in SRST. During normal operation calls are sent to the GW with 11 digits so I setup the SRST dial-peer to forward 11 digits on LD calls to the carrier. I have tried forwar...
Hello,
Scenario: Call Forward All to a 4 digit TP that expands out to E164 format. 5170 to +13309265170. +13309265170 is a CTI Route Point that CFA's to Unity Call Handler. I can dial 5170 and it works but if I try to CFA it goes lines voicemail bo...
I ran across this thread because one of the sites I support had this same issue. I was getting DSP Timeout errors and we reloaded the router and the DSP's came up in a FAIL STATE.
I then powered off the router (2951) completely and unplugged the cabl...
I ran across this thread because one of the sites I support had this same issue. I was getting DSP Timeout errors and we reloaded the router and the DSP's came up in a FAIL STATE.I then powered off the router (2951) completely and unplugged the cable...
Haha yea we still have some dinosaurs in our environment that are slowly being phased out. The SIP trace from Avaya was very generic with no helpful information that would indicate the underlying issue. I believe I found my answer, it seems the only ...
Do you have an example list? I have tried ACL's before and have not had success. My goal is to test SRST with a single phone before doing a cluster wide test.
The problem ended up being with the way I failed over my CIPC. I used a windows firewall rule to block communication to the Call Managers which allowed my CIPC to failover to the router and register. Even though my CIPC registered to the router and c...
