3GE-GBIC-SC NO. 1:
SLOT 4 (RP/LC 4 ): 3 Port Gigabit Ethernet
MAIN: type 68, 800-6376-05 rev C0
Deviation: D063031, D062881, D048296
HW config: 0x00 SW key: 00-00-00
PCA: 73-4775-07 rev D0 ver 2
Design Release 2.0 S/N XXXXXXXX
MBUS: Embedded Agent
Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00
DIAG: Test count: 0x00000000 Test results: 0x00000000
FRU: Linecard/Module: 3GE-GBIC-SC=
Processor Memory: MEM-GRP/LC-128=
Packet Memory: MEM-LC1-PKT-256=
L3 Engine: 2 - Backbone OC48 (2.5 Gbps)
MBUS Agent Software version 1.117 (RAM) (ROM version is 3.47)
ROM Monitor version 16.12
Fabric Downloader version used 10.1 (ROM version is 10.1)
Primary clock is CSC 1
Board is analyzed
Board State is Line Card Enabled (IOS RUN )
Insertion time: 00:10:52 (00:03:03 ago)
Processor Memory size: 134217728 bytes
TX Packet Memory size: 134217728 bytes, Packet Memory pagesize: 8192 bytes
RX Packet Memory size: 134217728 bytes, Packet Memory pagesize: 8192 bytes
0 crashes since restart
3GE-GBIC-SC NO. 2:
SLOT 5 (RP/LC 5 ): 3 Port Gigabit Ethernet
MAIN: type 68, 800-6376-01 rev E0
Deviation: 0
HW config: 0x00 SW key: 00-00-00
PCA: 73-4775-02 rev E0 ver 2
Design Release 2.0 S/N AAAAAAAA
MBUS: Embedded Agent
Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00
DIAG: Test count: 0x00000000 Test results: 0x00000000
FRU: Linecard/Module: 3GE-GBIC-SC=
Processor Memory: MEM-GRP/LC-128=
Packet Memory: MEM-PKT-512-UPG=
L3 Engine: 2 - Backbone OC48 (2.5 Gbps)
MBUS Agent Software version 1.117 (RAM) (ROM version is 2.32)
ROM Monitor version 16.6
Fabric Downloader version used 10.1 (ROM version is 10.1)
Primary clock is CSC 1
Board is analyzed
Board State is Line Card Enabled (IOS RUN )
Insertion time: 00:05:11 (00:03:58 ago)
Processor Memory size: 134217728 bytes
TX Packet Memory size: 268435456 bytes, Packet Memory pagesize: 16384 bytes
RX Packet Memory size: 268435456 bytes, Packet Memory pagesize: 16384 bytes
0 crashes since restart
-------QUESTION-------
We tried to install the 6 packet memory modules of 3GE-GBIC-SC NO. 2 to 3GE-GBIC-SC NO. 1 but the 3GE-GBIC-SC NO. 1 did not sync with the GRP-B. It seems that 3GE-GBIC-SC NO. 1 does not accept any packet memory modules higher than 256MB. Do we have to upgrade the firmware/version of the hardware? If yes, kindly provide us the procedure or any link on how to do upgrade the hardware.
Thank you and regards,
