cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
498
Views
0
Helpful
0
Replies
Highlighted

4GE-SFP-LC with 1GB not support FullBGP ipV4 and ipV6

Hi,

I have one 4GE-SFP-LC with Processor Memory: MEM-LC-ISE-1024 and Packet Memory: MEM-LC1-PKT-512

working with a PRP-1with 2Gb of RAM.

I received this message:

SLOT 1:Jun 21 22:23:21: %EE48-3-IPV6_TCAM_CAPACITY_EXCEEDED: IPv6 pkts will be software switched.

To support more IPv6 routes in hardware:

Get current TCAM usage with: show controllers ISE <slot> tcam

In config mode, reallocate TCAM regions e.g. reallocate Netflow TCAM to IPv6

  hw-module slot <num> tcam carve rx_ipv6_1 <prefix> <v6-percent>

  hw-module slot <num> tcam carve rx_top_nf <nf-percent>

Verify with show command that sum of all TCAM regions = 100%

Reload the linecard for the new TCAM carve config to take effect

WARNING: Recarve may affect other input features(ACL,CAR,MQC,Netflow)

So i try to carve the TCAM with these commands:

hw-module slot 1 TCAM carve RX_TOP_NF 23

hw-module slot 1 128 14 TCAM carve RX_IPv6_144b_REGION

But the problem persist.

Any suggestion will be appreciated,

Thanks

Everyone's tags (5)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards