Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Trying to help a customer I found an strange issue, if below configuration is present, all works fine:Router#show platformChassis type: ASR1009-XSlot Type State Insert time (ago)--------- ------------------- --------------------- -----------------...
Hi, We are trying to get a Nexus port (which is a span destination for Rx) to be up and transmit even if Rx is not connected in it. In other cisco platforms you could achieve this by using the no keepalive command but seems to be taken out in the N9K...
Hi, I'm wondering if there is any of the fabric extender models supported by the nexus 7000 that are able to do Q-in-Q (Dot1Q tunneling) on the host interfaces. If someone already have it working or know about it it will save my day. Best Regards,
Hi, I'm seeing a lot of FEC corrected words in an arista 7060 connected to a nexus 3232 and would like to know if there is a command to check that in cisco. Output from arista:localhost#show inter et58/4 phy detailEthernet58/4Current State Changes La...
Hi,I'm trying to do a throughput test with an A9K-2X100GE-TR in a 9006 V2 chassis with 2 x A9K-RSP880-SE prior to send it to customer and right now i'm capable of doing roughly 20Gbps traffic per port. RSP's are running 32bits 6.4.2 IOS-XR and all FP...
Hi,See attached a bit more info, take into account that these two chassis/card combination are exactly the same (and running the same IOS-XR) so, if was cosmetic, I would expect to have the same errors in both chassis: RP/0/RSP1/CPU0:W4A#show control...
Hi Aleksandar, Is a customer that plan to use it for route aggregation and not in full 100G but as our aggreement (i work as a external consultant for them) i need to test everything as full linerate (if possible) before even start digging on the con...
Hi and thanks for the answers Aleksandar and smilstea, Now i created a 10 streams traffic flow (so 10 streams of 10G) but it's doing roughly 40G:RP/0/RSP0/CPU0:ios#show inter hu0/0/0/0Tue Jul 30 16:27:04.631 UTCHundredGigE0/0/0/0 is up, line protocol...
Hi Again Georg, I just did another test changing some parameters in our spirent and finally i got it to work, looks like this card is more picky than the rest in term of traffic. Normally i never specify next protocol for the traffic generator as it ...
