dear friends,
I have WS-C6509-E ,whci has two Supervisor Engine 32 10GE .Suddenly it hung and customers could not do anything & they restarted by powering off and after that Iit is working fine up to now & never know whether it will happen again or not.
I managed to get following logs.Base on following logs(full log mentioned here) can anybody tell me what was the problem which caused to hang the switch?thanks
*Jun 12 05:02:23.119: RP: Currently running ROMMON from S (Gold) region
*Jun 12 05:02:23.971: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan. The Bridge IDs of all active STP instances have been updated, which might change the spanning tree topology
*Jun 12 05:02:28.775: %SYS-5-CONFIG_I: Configured from memory by console
*Jun 12 05:02:33.371: %SYS-5-RESTART: System restarted --
Cisco IOS Software, s3223_rp Software (s3223_rp-IPBASEK9-M), Version 12.2(33)SXI1, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Fri 27-Mar-09 11:40 by prod_rel_team
*Jun 12 04:52:21.691: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
*Jun 12 05:02:19.327: %SPANTREE-SP-5-EXTENDED_SYSID: Extended SysId enabled for type vlan. The Bridge IDs of all active STP instances have been updated, which might change the spanning tree topology
*Jun 12 05:02:32.620: %SYS-SP-5-RESTART: System restarted --
Cisco IOS Software, s3223_sp Software (s3223_sp-IPBASEK9-M), Version 12.2(33)SXI1, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
--More-- Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Fri 27-Mar-09 12:03 by prod_rel_team
*Jun 12 05:02:32.640: SP: Currently running ROMMON from S (Gold) region
*Jun 12 05:02:33.584: %OIR-SP-6-INSPS: Power supply inserted in slot 1
*Jun 12 05:02:33.588: %C6KPWR-SP-4-PSOK: power supply 1 turned on.
*Jun 12 05:02:33.652: %OIR-SP-6-INSPS: Power supply inserted in slot 2
*Jun 12 05:02:33.652: %C6KPWR-SP-4-PSOK: power supply 2 turned on.
*Jun 12 05:02:33.656: %C6KPWR-SP-4-PSREDUNDANTBOTHSUPPLY: in power-redundancy mode, system is operating on both power supplies.
*Jun 12 05:02:35.135: %SNMP-5-COLDSTART: SNMP agent on host QURUM_Core is undergoing a cold start
*Jun 12 05:02:40.951: %DIAG-SP-6-RUN_MINIMUM: Module 5: Running Minimal Diagnostics...
*Jun 12 05:03:06.267: %DIAG-SP-6-DIAG_OK: Module 5: Passed Online Diagnostics
Jun 12 05:03:07.571: %MFIB_CONST_RP-6-REPLICATION_MODE_CHANGE: Replication Mode Change Detected. Current system replication mode is Ingress
*Jun 12 05:03:07.859: %OIR-SP-6-INSCARD: Card inserted in slot 5, interfaces are now online
*Jun 12 05:03:07.919: %DIAG-SP-6-RUN_MINIMUM: Module 1: Running Minimal Diagnostics...
*Jun 12 05:03:08.959: %DIAG-SP-6-RUN_MINIMUM: Module 4: Running Minimal Diagnostics...
Jun 12 05:03:18.563: %CAPI_EC-4-RATE_LIMITED: Adding interfaces on WS-X6148-GE-TX to an etherchannel will limit channel throughput to 1 Gbps!
--More-- *Jun 12 05:03:17.468: %DIAG-SP-6-DIAG_OK: Module 1: Passed Online Diagnostics
Jun 12 05:03:18.571: %CAPI_EC-4-RATE_LIMITED: Adding interfaces on WS-X6148-GE-TX to an etherchannel will limit channel throughput to 1 Gbps!
Jun 12 05:03:18.579: %CAPI_EC-4-RATE_LIMITED: Adding interfaces on WS-X6148-GE-TX to an etherchannel will limit channel throughput to 1 Gbps!
Jun 12 05:03:18.583: %CAPI_EC-4-RATE_LIMITED: Adding interfaces on WS-X6148-GE-TX to an etherchannel will limit channel throughput to 1 Gbps!
*Jun 12 05:03:19.790: %OIR-SP-6-INSCARD: Card inserted in slot 1, interfaces are now online
*Jun 12 05:03:20.658: %DIAG-SP-6-DIAG_OK: Module 4: Passed Online Diagnostics
*Jun 12 05:03:21.018: %OIR-SP-6-INSCARD: Card inserted in slot 4, interfaces are now online
Jun 12 05:03:25.168: %PFREDUN-SP-6-ACTIVE: Standby initializing for SSO mode
Jun 12 05:03:25.336: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
Jun 12 05:03:36.342: %PFINIT-SP-5-CONFIG_SYNC: Sync'ing the startup configuration to the standby Router.
Jun 12 05:04:34.515: %DIAG-SP-6-RUN_MINIMUM: Module 3: Running Minimal Diagnostics...
Jun 12 05:04:37.331: %DIAG-SP-6-DIAG_OK: Module 3: Passed Online Diagnostics
Jun 12 05:04:38.335: %SVCLC-5-FWVTPMODE: VTP mode is set to non-transparent
Jun 12 05:04:38.779: %DIAG-SP-6-RUN_MINIMUM: Module 2: Running Minimal Diagnostics...
--More-- Jun 12 05:04:39.539: %DIAG-SP-6-DIAG_OK: Module 2: Passed Online Diagnostics
Jun 12 05:04:40.395: %OIR-SP-6-INSCARD: Card inserted in slot 2, interfaces are now online
Jun 12 05:04:47.637: %OIR-SP-6-INSCARD: Card inserted in slot 3, interfaces are now online
Jun 12 05:05:51.171: %DIAG-SP-6-RUN_MINIMUM: Module 6: Running Minimal Diagnostics...
Jun 12 05:05:53.267: %DIAG-SP-6-DIAG_OK: Module 6: Passed Online Diagnostics
Jun 12 05:05:54.171: %OIR-SP-6-INSCARD: Card inserted in slot 6, interfaces are now online
*Jun 12 05:02:30.239: %SYS-SPSTBY-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
*Jun 12 05:03:02.379: %SPANTREE-SPSTBY-5-EXTENDED_SYSID: Extended SysId enabled for type vlan. The Bridge IDs of all active STP instances have been updated, which might change the spanning tree topology
Jun 12 05:05:25.371: %DIAG-SPSTBY-6-RUN_MINIMUM: Module 6: Running Minimal Diagnostics...
Jun 12 05:05:49.715: %DIAG-SPSTBY-6-DIAG_OK: Module 6: Passed Online Diagnostics
Jun 12 05:06:19.351: %SYS-SPSTBY-5-RESTART: System restarted --
Cisco IOS Software, s3223_sp Software (s3223_sp-IPBASEK9-M), Version 12.2(33)SXI1, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
--More-- Compiled Fri 27-Mar-09 12:03 by prod_rel_team
Jun 12 05:06:19.355: SPSTBY: Currently running ROMMON from S (Gold) region
Jun 12 05:06:32.463: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
Jun 12 05:06:33.019: %PFREDUN-SPSTBY-6-STANDBY: Ready for SSO mode
Jun 12 05:06:33.295: %RF-SP-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
Jun 12 05:06:33.183: %SYS-SPSTBY-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
