7206 VXR configuration to pass MPLS Traffic

[NPT_2]

I have a 7206 VXR router between a several Mikrotik routers on our backbone.  We have the Mikrotiks on both sides of the CIsco 7206VXR setup for MPLS/VPLS.  I need to simply setup the 7206 to pass the MPLS/VPLS tagged packets to the next router on the link.  We are using OSPF as the routing protocol.  I am told by our Mikrotik guy that I just need to enable LDP and VPLS tunnels 4:0 on the 2 gig interfaces on the 7206VXR to let it pass the MPLS/VPLS traffic.  It sounds simple but I'm not sure how to do this. 

Does anyone have the commands I need to imput to allow this router to pass this MPLS/VPLS traffic. 

Thanks,

Jim

[Reza Sharifi]

You basically need to add

mpls labe protocol ldp in global config and also mpls ip for the incoming and outgoing interface.

have a look at the config guide config example:

http://www.cisco.com/en/US/docs/ios/mpls/configuration/guide/mp_ldp_overview_ps6922_TSD_Products_Configuration_Guide_Chapter.html

HTH