Hi, just recieved some new Cisco 2901 routers (replacing older 2811's). It came with c2900-universalk9-mz.SPA.154-3.M1.bin loaded on. Is this the best IOS for this router? There is one newer one but its an early deployment release. There is an ol...
Hi, just recieved some new Cisco 2901 routers (replacing older 2811's). It came with c2900-universalk9-mz.SPA.154-3.M1.bin loaded on. Is this the best IOS for this router? There is one newer one but its an early deployment release. There is an ol...
Hello I am trying to setup a p-p serial interface link and see the following: Config on side A interface Serial0/2/3 bandwidth 512 ip address 192.168.241.1 255.255.255.252 ip virtual-reassembly in encapsulation frame-relay load-interval 30 serial res...
If a non existent route-map is referred in a redistribute command . How does it effect ?Example configurationaddress-family ipv4 vrf VRF:MMS:MGD:XLC:190 redistribute connected route-map MGD_XLC redistribute static route-map VPN_XLC no synchronizat...
Good day I'm not a Cisco trained technician but i have a idea what to do when setting them up. But this one is throwing me for a loop. i received a Cisco 887 Router Part number: 341-0135-03 to add a new ISP's details. Reset the router using the re...
HiYesterday afternoon we experienced an issue where 2 Cisco 7609 (Sup 720 3BXL) routers functioning as PE devices maxed out the CPU for a lengthy period of time. This caused huge BGP instability. The main processes taking the CPU time were either t...
i am unable to run "#router bgp XXX" on this new cisco "WS- C4500X-32" running image "cat4500e-universalk9.SPA.03.05.02.E.152-1.E2.bin". any quick comment is much appreciated. seeing this message "Protocol not in this image" while i try to add route...
Hi, My question is regarding the "Source ID" field that appears in Netflow V.9 packet header. Following Cisco link (http://www.cisco.com/en/US/technologies/tk648/tk362/technologies_white_paper09186a00800a3db9.pdf) gives Source ID definition as - "The...
Hello,Please confirm if my presentation is correct. Thank you very much in advance.... First, I have called Telstra to ask what is the upload speed of the link in our atm link. They said it is 910Kbps.Then I checked also our router and I have execut...
Dear All, As we know, BGP peer relation needs reachability of tcp 179. But usually if the two peer neighbors can ping each other, we can consider the tcp 179 is working well. So what is relationship between ping and tcp in BGP in this situation ? Th...
Hello, the baud rate got changed of the 2702i aironet device by an accidental cut and paste from a wrong script and I'm trying to set it back so we can update the image to autonomous from lightweight and use this access point.I tried most of the baud...
I was wondering what your thoughts would be on a 2911 for handling a full Internet routing table. We have two 2911s peering with two different providers using BGP and iBGP between the two 2911s. We've been having some significant Internet slow downs ...
Hello Community Team, I have an error in this card.The show platform issues the following error: ASR-1004-IBM#show platformChassis type: ASR1004 Slot Type State Insert time (ago) --------- ------------...
HiI got a problem with a catalyst 4503 regarding the configuration lock.Now I can enter in configure terminal but I cannot configure anything.If I try to set something in configuration I will receive this output:Configuration mode locked exclusively ...
Hi,Can any one of you help me with an explanation why I am seeing the 1:1 static NATed IP getting patted as well with the below setup. It is some times getting patted using the internal IP (172.X.X1.2) and <public IP1>. And this happening only for th...
Hello,We are planning to replace the existing router with Cisco router with at least 4 ten Gig port.I am thinking of 1000 series of cisco router.I am using it for BGP boarder router accepting full routing table.Pls suggest me if there is any better o...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
06-14-2025 01:24 AM | ||
05-12-2025 03:28 PM | ||
05-09-2025 02:25 PM | ||
05-05-2025 11:47 PM | ||
04-22-2025 12:20 PM |
User | Count |
---|---|
9 | |
7 | |
4 | |
4 | |
3 |