02-13-2014 09:45 PM - edited 03-04-2019 10:20 PM
Hi,
I have replaced my Cisco 7609's faulty RPS720 (RSP720-3C-GE) with the new one on its module 5. After plugin the module into slot 5 , I am getting the below output. Since I am new to this series router, please suggest me how to configure this sup. ( Initially module 5 was Active and 6 was in standby)
RTR-2#sh module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX
3 0 2-subslot Services SPA Carrier-400 7600-SSC-400
4 0 4-subslot SPA Interface Processor-200 7600-SIP-200
5 0 Supervisor-Other Unknown Unknown
6 2 Route Switch Processor 720 (Active) RSP720-3C-GE
7 0 4-subslot SPA Interface Processor-200 7600-SIP-200
8 0 4-subslot SPA Interface Processor-200 7600-SIP-200
RTR-2#sh redundancy states
my state = 13 -ACTIVE
peer state = 1 -DISABLED
Mode = Simplex
Unit = Secondary
Unit ID = 6
Redundancy Mode (Operational) = sso
Redundancy Mode (Configured) = sso
Redundancy State = Non Redundant
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
client count = 146
client_notification_TMR = 30000 milliseconds
keep_alive TMR = 9000 milliseconds
keep_alive count = 0
keep_alive threshold = 18
RF debug mask = 0x0
RTR-2#sh redundancy
Redundant System Information :
------------------------------
Available system uptime = 1 week, 5 days, 13 hours, 45 minutes
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Simplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 6
Current Software state = ACTIVE
Uptime in current state = 1 week, 5 days, 13 hours, 45 minutes
Image Version = Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRE2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Thu 05-Aug-10 18:59 by prod_rel_team
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: unavailable) information is not available because it is in 'DISABLED' state
Regards,
Anil
02-14-2014 02:28 AM
Hi,
The Supervisor on the Slot 5 might be on Rommon mode. Console into the Slot 5 Sup and try to boot it from there.
Thanks
Ankur
"Please rate the post if found useful"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide