Showing results for 
Search instead for 
Did you mean: 

886VAW not syncing @ ADSL

Dan Jay
Level 1
Level 1

Dear all,

my newly purchased 886VAW won't sync.

The link ( ISDN ) I'm running it off from runs nicely on my crusty-trusty 803. I linked the box

with the cables supplied against the splitter as usual but can't seem to get a stable CD light ( constantly flashing ).

The box is intended to run against ADSL (with VDSL to come in a few days ).

Can someone shed some light on what I am doing wrong ?

Controller VDSL 0 is DOWN

Daemon Status:           Establishing Link

                        XTU-R (DS)              XTU-C (US)

Chip Vendor ID:         'BDCM'                   'IFTN'

Chip Vendor Specific:   0x0000                   0x71B8

Chip Vendor Country:    0xB500                   0xB500

Modem Vendor ID:        'CSCO'                   '    '

Modem Vendor Specific:  0x4602                   0x0000

Modem Vendor Country:   0xB500                   0x0000

Serial Number Near:                C886VA-W 15.1(4)M

Serial Number Far:

Modem Version Near:    15.1(4)M

Modem Version Far:     0x71b8

Modem Status:            Idle

DSL Config Mode:         AUTO

Trained Mode:

TC Mode:                 UNKNOWN

Selftest Result:         0x00

DELT configuration:      disabled

DELT state:              not running

Trellis:                 OFF                      OFF

Full inits:             0

Failed full inits:      11

Short inits:            4

Failed short inits:     6

Firmware        Source          File Name (version)

--------        ------          -------------------

VDSL            embedded        VDSL_LINUX_DEV_01212008 (1)

Modem FW  Version:      110506_1916-4.02L.03.B2pvC032b.d23i

Modem PHY Version:      B2pvC032b.d23i

Training Log :  Stopped

Training Log Filename : flash:vdsllog.bin

sho run int ATM0:

interface ATM0

no ip address

atm vc-per-vp 64

no atm ilmi-keepalive


interface ATM0.1 point-to-point

no ip redirects

no ip unreachables

no ip proxy-arp

ip flow ingress

pvc 1/32

  pppoe-client dial-pool-number 2



2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Update VDSL firmware. Also can try configuring DSL manually.

Dan Jay
Level 1
Level 1

All fixed - pin in Splitter torn off........

Review Cisco Networking for a $25 gift card