ACL for NAT translation

[Michel_VZ]

Hello,

I have managed to setup nat translation for a internal webserver i have running. I followed this guide: http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093e51.shtml and everything seems to be working fine, except for the fact i dont have a acl defined for users who are trying to access my webserver from the outside (internet). Since i only want to allow access to the internal webserver from a specific outside ip address.

How would i do this?

Thank you.

[Karsten Iwen]

The needed steps depend on your existing config. What is your actual outside-interface-config and incoming access-list on that interface?

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni