Routing

HelloI'm currently working on creating a route-map for a BGP configuration and am stumped.I have two different routers behaving the same way so that's the confusing part.I'm trying to apply a route-map in the following fashion;router bgp 65004neighbo...

Hi allcan anyone tell me what people generally use bgp communites for ? can you give me an example of influencing routes via sending my community ?cheers                  

Good day and Thanks in advance for your help.Reading about FlexStack modules I had a couple of doubts , maybe this is not the correct section , if it isn't I apologize.The first one:Is the FlexStack form factor standard? For being precise, does it su...

I have the following network (full internal AS 34 bgp mesh):I applied the bgp default local-preference 400 command on R3 and as I suspected nothing changed (it only has iBGP peers).I applied the same command on R1 and it changed the local preference ...

Hello,We have a very weird issue: We own several public IP addresses. When we have a service that needs internet public access, we just create a NAT rule that points from 1 of our public IP addresses to the server in our LAN where the service resides...

Hi,I set up Catalyst6500 Quad-SUP VSS system.I have a problem with slow BGP convergence(80sec) on VSS switchover.Each chassis has a bgp peer and "bgp graceful-restart" is disabled.I investigated BGP behavior with "debug ip bgp events" and "debug ip b...

Is there a bandwidth utilization percentage that is considered "healthy?"  We run our WAN link at 99% utilization.  The QoS should be doing its job and dropping less critical packets.Vince

I'm getting the following errors logged on one my 2811 routers with dual ADSL cards. The ATM0/1/0 status is also sat at initializing. Anyone any idea what the problem might be.HWIC_ADSL_BRI-7-NETSPURIOUSEVENT: HWIC_ADSL_BRI 1: Spurious network interr...

I have Cisco 3845 with two Gigabit interfaces configured as port-channel with subinterface and with QoS.However shape does not work, any ideas why?interface Port-channel1.1400encapsulation dot1Q 382ip address 10.10.10.3 255.255.255.0service-policy ou...

I purchased a RV082 router because it said it would support VLANs, but I cant seem to get it set up how I want.I would like the first internet port on the router to feed one VLAN with an IP address.I would like the second internet port (DMZ / Interne...

Hello, I have a weird issue, I have dual WAN, WAN1 is a bonded 3.0Mbit T1 and WAN2 is a Coaxial 15x3 Mbit Cable connection, I am having all the HTTP 80 traffic go through WAN2 but for some reason when I do a speed test it only gives me about 3 or 4 M...

My name is David.  I currently run a small 52 people BPO and we are soon moving a to a larger 350 people capacity.  I wonder if someone comment on the following:-  We currently use DLink routers, which are quite limiting in terms of features.  We are...