Cisco 7606S with dual RSP720-3C-GE 2 engines
Both running same IOS and package files.
Both Config Registers are as follows:
Configuration register is 0x2102
The only difference that I see are Modules 5 & 6 Revision numbers are different and the Bootstrap loader is different on each device. See Below..
When performing the "redundancy force-switchover" command the device fails over to the Hot Standby, but the original master goes into ROMMON
NAME: "module 5", DESCR: "RSP720-3C-GE 2 ports Route Switch Processor 720 Rev. 5.9"
PID: RSP720-3C-GE , VID: V09, SN: JAE142704O2
OID: 1.3.6.1.4.1.9.12.3.1.9.29.51
NAME: "msfc sub-module of 5", DESCR: "7600-MSFC4 C7600 MSFC4 Daughterboard Rev. 1.5"
PID: 7600-MSFC4 , VID: 000, SN: JAE142702DZ
OID: 1.3.6.1.4.1.9.12.3.1.9.17.72
NAME: "switching engine sub-module of 5", DESCR: "7600-PFC3C Policy Feature Card 3 Rev. 1.2"
PID: 7600-PFC3C , VID: 000, SN: JAE14260QP8
OID: 1.3.6.1.4.1.9.12.3.1.9.17.94
NAME: "module 6", DESCR: "RSP720-3C-GE 2 ports Route Switch Processor 720 Rev. 5.2"
PID: RSP720-3C-GE , VID: V09, SN: JAE1211B8A6
OID: 1.3.6.1.4.1.9.12.3.1.9.29.51
NAME: "msfc sub-module of 6", DESCR: "7600-MSFC4 C7600 MSFC4 Daughterboard Rev. 1.1"
PID: 7600-MSFC4 , VID: 000, SN: JAE1211B7HV
OID: 1.3.6.1.4.1.9.12.3.1.9.17.72
NAME: "switching engine sub-module of 6", DESCR: "7600-PFC3C Policy Feature Card 3 Rev. 1.1"
PID: 7600-PFC3C , VID: 000, SN: JAE1211B85M
OID: 1.3.6.1.4.1.9.12.3.1.9.17.94
