Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently upgraded IOS-XR code from 5.3.3 to 5.3.4 and now receiving the following message during reboot or power on cycle: RP/0/RSP1/CPU0:Jun 16 05:26:24.631 : licmgr[316]: %LICENSE-LICMGR-4-PACKAGE_LICENSE_INVALID : Package requesting A9K-LI-LIC l...
Hi folks,
I am looking for a Cisco SFP datasheet for both Copper and Fiber SFP's that shows all the Chassis\Modules they support? Is there a such a list on Cisco's website? Any assistance is appreciated. Thanks
We have WAN transport that runs from Hawaii to SC (distance is approx 4700 miles) and rides two DISA MSPP circuits for the entire path between the sites. We connect to a SONNET RING (15454 ONS) in SC to the final end point in the network. The netwo...
If i perform a factory rest on a Cisco N540-24Q8L2DD-SYS will it remove all of the license files that are on the device? Trying not to create another problem for myself. Would it just be easier to wipe the configuration? If so what are the commands ...
Cisco 7606S with dual RSP720-3C-GE 2 engines
Both running same IOS and package files.
Both Config Registers are as follows:
Configuration register is 0x2102
The only difference that I see are Modules 5 & 6 Revision numbers are different and the Boot...
Do the RSP system bootstrap versions have to match in order for sso redundancy switch over to work correctly? Everytime I power cycle my Cisco 7606S device the Master RSP boots up just fine but the Hot Standby does not.
I have verified that both RS...
