ASR 1001 voice command issue
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2016 12:43 PM - edited 03-05-2019 03:34 AM
Hello Experts;
I am unable to configure ASR 1001 with voice configurations for SIP . There is no voice commands are showing under configuration terminal
Any help would be higly apreciated
KV
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2016 08:46 PM
Are you running 3.7S or later?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2016 12:03 AM
Cisco IOS XE Software, Version 03.16.01a.S - Extended Support Release
Cisco IOS Software, ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(3)S1a, RELEASE SOFTWARE (fc1)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2016 08:49 PM
Which licence(s) have you got?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2016 12:04 AM
License Level: ipbase
License Type: Permanent
Next reload license Level: ipbase
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2016 02:30 PM
Which actual voice command where you trying to use? I'm thinking you might need an "IP Services" licence.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-24-2016 03:44 AM
Hello
I think you need to have UC license for the box as IP base will not cover that. Also check the module for SIP
