ASR-920 Port Channel Support

[ZK916]

Hello, 

We currently have a Cisco ASR-920-4SZ edge router which has a single 10G link to a stack of edge switches. We are trying to build a fault-tolerance by configuring a port-channel and configuring 2 X 10G interfaces. I wanted to find out if that ASR-920-4SZ router support port-channeling (L2 or L3 port-channeling). Any thoughts? 

Thanks in advance. 

\

Best, ~zK 

[MHM Cisco World]

I already lab this before 
IOS XE support PO L3 and you can use mode ON 

[ZK916]

@MHM Cisco World .. thanks for quick reply.

Does it also support PO L2?

[MHM Cisco World]

I dont try before but 
if you try 
interface port-channel x
switch port <<- if this accept by ASR then you can config it