Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I setup a simple lab using GNS3 for proof of concept -- diagram attached for illustration. R1:vlan database; VLAN 3 and VLAN 210interface Port-channel1no ip addresshold-queue 150 in!interface Port-channel1.3encapsulation dot1Q 3ip address 10.3...
Hello, I've attached a diagram to illustrate the topology I am working on. I configured R1 with a Layer 3 port-channel interface and configured two physical member interfaces as routed ports and linked them to two switches. Each switch has a an acces...
Hello,
We currently have a data center connected to a single ISP (ISP xyz). We have a single internet edge router which connects to the ISP using BGP.
We plan to have a tenant share our internet link but have their own internet edge router. The de...
Hello, all and @Royalty
We currently have two Data Centers. Each data center has a 100Gbps Internet connection. We have a Cisco ASR1001 edge router which connects to a core switch on the LAN side.
I am considering two SD-WAN design options for th...
Hello,
We have a new site where we are planning on installing brand new WAP units (CW9166I-B) and C9800 WLC. This is a green field deployment. Our wireless vendor is telling us that the CW9166I-B units are Meraki Cloud and not Cisco when you first i...
M02@rt37 ... this is very helpful.. The two switches (ESW1 and ESW2) will be virtualized using SV. How can this issue be resolved? I mean where would you configure the common transit subnet? Thanks in advance. Best, ZK
Thanks for the feedback!
Actually, we have 2 DCs. Each DC represents a hub. We use the same ISP at both DCs for the Internet access. This is a hub-spoke design where the spokes will prefer one sending traffic to one hub (DC1) over another (DC2). In t...
