08-24-2020 09:50 AM
Hello Everyone
I need your help
What is the command to validate subslot 0/1 transceiver 3 Rx and TX Power Sensor
Our monitoring system is detecting alarms about that
Thanks very much
Solved! Go to Solution.
08-24-2020 11:43 AM
Hello,
the command:
show hw-module subslot 0/1 transceiver 3 idprom detail
should list the thresholds...
08-24-2020 11:11 AM
Hello,
try the command:
show interfaces diagnostics optics interface
08-24-2020 11:19 AM
01#show interfaces diagnostics optics ?
% Unrecognized command
I try this:
01#show hw-module subslot 0/1 transceiver 3 status
The transceiver in slot 0 subslot 1 port 3
has been disabled because:
the port is in shutdown state
Module temperature = +24.878 C
Transceiver Tx supply voltage = 3321.7 mVolts
Transceiver Tx bias current = 16 uAmps
Transceiver Tx power = -15.6 dBm
Transceiver Rx optical power = -40.0 dBm
What is the threshold ?
Look at it
Transceiver Rx optical power = -40.0 dBm
Transceiver Tx power = -15.6 dBm
08-24-2020 11:43 AM
Hello,
the command:
show hw-module subslot 0/1 transceiver 3 idprom detail
should list the thresholds...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide