I have four T1 with ATM IMA configuration. The ATM interfaces are up/up state; However, when I bound the ima-group 0 statement to the ATM interfaces, the four atm interfaces will goes down. Do anyone have any idea about this? Am i missing anything on the config?
Thanks,
Peter
interface ATM1/0
no ip address
no atm oversubscribe
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/1
no ip address
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/2
no ip address
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/3
no ip address
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
pvc 2/35
interface ATM1/IMA0
description IMA Group 0
no ip address
no atm ilmi-keepalive
ima clock-mode independent
!
interface ATM1/IMA0.1 point-to-point
bandwidth 6000
ip address 168.x.x.x 255.255.255.128
ip access-group 101 in
no ip unreachables
crypto map clientmap
pvc 2/35