Bad file magic number 0x0 ... cannot load "flash"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2013 11:43 AM - edited 03-04-2019 07:18 PM
Hi All,
I'm studying for my CCNA, I'm currently in the later stages of ICND 1.
My problem is IOS related and is as follows:
As part of my network lab I have bought a reconditioned 2600 series routrer (2610XM), which, when it arrived was working just fine. However, something occured which seems to have corrupted the flash file, If I knew what then I would state it here, but I don't, I have a strong suspicion it may be the result of pulling the USB - DB9 out whilst the a connection was still active. Anyway, I am where I am. And that's stuck in ROMmon mode.
I've checked Config Summery and changed configuration and re-booted, as recommended, which got me nowhere.
Next, I looked for a valid image in flash using the "dir flash:" cmd which came back with the followed results:
File Size: 896 bytes (0x380), Checksum: 0x306e, File Name: Start-up
Am I correct in assuming that this means there is no flash file?
Next, I started an xmodem procedure, this was going well right up untill the time when I needed to download the appropriate file from Cisco. I was able to navigate to the download page for flash file: WIC-xAM-V2-F49-1922F-4M-image.bin. However, when I tried to download the file I was halted with the details that I "don't have a valid service contract associated with my cisco.com profile."
So, I'm stuck, in ROMmon mode to be procise.
Does anyone have any suggestions of what I should do next?
Many thanks,
Olly.
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2013 03:59 PM
Can you please post the entire bootup process?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2013 12:18 AM
Hi Leolaohoo - Please see the attached doc for start-up process.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2013 12:21 AM
Okaaaaay ... Please post the output to the command "dir flash:".
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2013 11:36 AM
Hi
dir flash: output attached.
Olly.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2013 03:43 PM
Someone erased your IOS.
Xmodem Procedure for Downloading a Cisco IOS Software Image onto a Cisco 2620 Router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2013 04:41 AM
Thanks Leolaohoo, but, that's the part I know. My problem is that I can't download the IOS from Cisco without having a service contract.
The file I need is WIC-xAM-V2-F49-1922F-4M-image.bin, do you know of another way of downloading the IOS file to my machine so I can carry out the xmodem prcedure????
