Hello Expert,
I am trying to configure bandwidth limiting.
I am using a workstation with an address defined in object-group Sec_group to send a large file.
The file transfer did not show any evidence of been limited from the results, no traffic was been defined in the correct category( Class-map: OR_CAM ) and all went to class-default category
I would be grateful if any one can examining same and provide a fix.
Below is relevant configuration I did on the router.
access list
-----------------------
ip access-list extended OR_PERM
remark CCP_ACL Category=1
permit ip object-group Sec_group host 172.pp.30.41
class Map
----------------------
Camp_Street#sh class-map
Class Map match-any OR_CAM (id 1)
Match access-group name OR_PERM
Class Map match-any class-default (id 0)
Match any
Policy-map
----------------------------
Camp_Street#sh policy-map
Policy Map OR_CAM_LIMIET
Class OR_CAM
police cir 56000 bc 1750
conform-action transmit
exceed-action drop
interface GigabitEthernet0/0
description Wireless Interface$ETH-WAN$
ip address 10.10.1xx.qq3 255.255.255.0
no ip redirects
ip pim dense-mode
duplex auto
speed auto
crypto map SDM_CMAP_1
!
service-policy input OR_CAM_LIMIET
Result in real time
------------------------
Service-policy input: OR_CAM_LIMIET
Class-map: OR_CAM (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: access-group name OR_PERM
0 packets, 0 bytes
5 minute rate 0 bps
police:
cir 56000 bps, bc 1750 bytes
conformed 0 packets, 0 bytes; actions:
transmit
exceeded 0 packets, 0 bytes; actions:
drop
conformed 0 bps, exceed 0 bps
Class-map: class-default (match-any)
241485 packets, 103290758 bytes
5 minute offered rate 1081000 bps, drop rate 0 bps
Match: any
Regards
