04-27-2024 03:51 PM
I'm configuring this topology
I'm puzzled by R6 receiving R2 prefixes because they originate from a remote AS, so they should arrive with a TTL set to 1. I previously utilized EBGP multihop, but I've since removed it, yet the prefixes persist.
I'm not triying to remove them. I'm just trying to understand BGP behavior.
Solved! Go to Solution.
04-27-2024 04:20 PM
The prefix of bgp done have TTL
But TTL is mandatory for bgp session to establish.
How can I know ttl in active bgp session?
This info dont find it even in ccie book' you can see ttl of active bgp by
Show tcp breif
There is number appear "pcb" number
Use it in
Show tcp detail pcb "number you get from first step"
MHM
04-27-2024 04:20 PM
The prefix of bgp done have TTL
But TTL is mandatory for bgp session to establish.
How can I know ttl in active bgp session?
This info dont find it even in ccie book' you can see ttl of active bgp by
Show tcp breif
There is number appear "pcb" number
Use it in
Show tcp detail pcb "number you get from first step"
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide