Hi,
This is my setup:
Cisco 2811 with FastEthernet0/1 connected to a G.SHDSL modem link, and an ADSL WIC interface connected to ADSL line.
I would like to bond the ADSL dialer interface (Dialer1) and the FastEthernet interface to use a single WAN IP address and allowing inbound/outbound load sharing/balancing across the two physical WAN links. I would like to be able to remotely access this router by telneting into the single WAN IP address and for the connection to use the bonded (ADSL+FastEth) interface.
If anyone has any information on how this can be configured on a Cisco 2811, it would be appreciated.
Here is a section of the config:
------
interface FastEthernet0/1
description G.SHDSL Internet
ip address g.shdsl_IP 255.255.255.252
ip load-sharing per-packet
duplex auto
speed auto
!
interface ATM0/0/0
no ip address
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0/0/0.1 point-to-point
description ADSL Internet
no snmp trap link-status
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
!
interface Dialer1
ip address negotiated
ip load-sharing per-packet
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap callin
ppp chap hostname username
ppp chap password password
!
-----
Thanks in advance.
Vasko.