Break Sequence for ASR 1002-X

[gbenoit83]

Hello,

I have made a rookie mistake while configuring my ASR 1002-X Router. I have put our network radius

server ip

and logon information to log on to the router with radius. I did not out in the emergency or local account onto the router before I put the radius information on the router. Since this router is not touching the network yet, it cannot get to the radius server. It will not connect to the network until it is configured locally. 

I have tried using break commanc sequences with no success. The laptop I am using to console in doe snot have a Break key, so I cannot use the

CTRL+Break

What can I do to get into rommon mode? 

Thank you

[Julio E. Moisa · Accepted solution]

Hi

Control + Break

should work, also try

Control + Pause

during the booting. 

[gbenoit83]

Thank you for the sequence. There was not a break on my keyboard. So i tried

Ctrl+Pause

and it worked. Found out the special command from teh Putty drop down works as well.

Thanks Julio