C1111-8P booting into ROM

[Linxuwiz12]

I am new to this Cisco Router. I bought this router with the below specs when I turn on the router it is going straight into "ROMMON" Mode how do load the new firmware. Your help will be greatly appreciated.

General InformationManufacturer: Cisco Systems, IncManufacturer
Part Number: C1111-8PManufacturer
Website Address:
http: //www. cisco.
comBrand Name: CiscoProduct
Series: 1100Product
Model: C1111-8PProduct
Name: C1111-8P
Integrated Services RouterMarketing Information: 
Product Type: RouterInterfaces/PortsTotal Number of
Ports: 10Management
Port: YesNumber of
Network (RJ-45) Ports: 8Number of
WAN Ports: 2I/O ExpansionsNumber of Total
Expansion Slots: 1Expansion
Slot Type: SFP
Network & CommunicationEthernet Technology: Gigabit
EthernetNetwork Technology: 10/100/1000Base-TXPower DescriptionPoE (RJ-45)

[Leo Laohoo]

While in ROMMON, post the complete output to the following commands: 

1.  dir flash:

2.  set

[Linxuwiz12]

I typed in boot on rommon it loaded package.conf file after a few minutes it gave the router prompt. I typed in reload

gave the following output

WARNING: 

Boot variable either does not exist or buffer is too small

This may impact autoboot of the router. Proceed with caution

Do you wish to proceed with reload anyway[confirm]n

Router#reload

BOOT variable = 

CONFIG_FILE variable does not exist

BOOTLDR variable does not exist

Configuration register is 0x2122

Standby not ready to show bootvar

[Linxuwiz12]

my apologies Leo I unable to type that command since it is now at the Router prompt.

[Leo Laohoo]

---

@Linxuwiz12 wrote:

Configuration register is 0x2122

---

To fix this, do this: 

conf t
 config-registry 0x2102
end
wr