My previous post was marked as spam for some reason so posting again...I have a 3750G and 3750E and I cannot seem to get either to export any netflow data. The "show ip flow export" has nothing in it. I have tried version 5 and 9 and also tried just doing ingress and egress commands on specific interfaces with export and source flow commands in global config. The goal is too use this with PRTG network monitor. Not sure if previous post was marked as spam because I posted configs?
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...