Doing a project for my job interview,
one of my goals is to connect everything using different technologies,
I did multi area OSPF here with a back bone and all
R4 and R0 connect well to R2,R5,R6 and R6 connect to R4 and R0
The problem is with R3 and R7
They connect well inside of the their area, R3 pings R0,R4,R1 and R7 pings R6 and R5
but both of them cant ping outside their of their area.
here is the commands :
for R3:
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface FastEthernet0/0.111
encapsulation dot1Q 111
ip address 172.17.111.254 255.255.255.0
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
shutdown
!
interface Serial0/0/0
ip address 10.17.12.9 255.255.255.252
!
interface Serial0/1/0
no ip address
clock rate 2000000
shutdown
!
interface Serial0/2/0
no ip address
clock rate 2000000
shutdown
!
interface Serial0/3/0
no ip address
clock rate 2000000
shutdown
!
interface Vlan1
no ip address
shutdown
!
router ospf 10
router-id 1.1.1.1
log-adjacency-changes
passive-interface FastEthernet0/0
network 10.17.111.0 0.0.0.255 area 22
network 10.17.12.8 0.0.0.3 area 22
for R7:
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface FastEthernet0/0.45
encapsulation dot1Q 45
ip address 10.17.45.253 255.255.255.0
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
!
interface Serial0/0/0
ip address 10.17.12.22 255.255.255.252
clock rate 2000000
!
interface Serial0/1/0
no ip address
clock rate 2000000
shutdown
!
interface Serial0/2/0
no ip address
clock rate 2000000
shutdown
!
interface Serial0/3/0
no ip address
clock rate 2000000
shutdown
!
interface Vlan1
no ip address
shutdown
!
router ospf 10
router-id 2.2.2.1
log-adjacency-changes
passive-interface FastEthernet0/0
network 10.17.45.0 0.0.0.255 area 10
network 10.17.12.20 0.0.0.3 area 10
Accepted Solutions
