04-28-2008 06:03 AM - edited 03-03-2019 09:43 PM
Hello, i have a 6513 switch with a SUP720 supervisor module running v6.2.18 SXF11 and have a Microsoft NLB problem requiring a Static MAC address configuration to fix the problem..
I have tried to apply the command: -
mac-address-table static 02bf.0a30.011e vlan 20 interface gi12/11 gi12/12 po1
But the command errors at the "g" on the second interface definition.
Adding the command 3 times, each with a single interface doesn't work either, as each one overwrites the previous one.
i have done this in the past on other software versions and it has worked, but i cannot find out why this now doesn't work - am i doing something wrong?
04-29-2008 12:27 AM
Hi
I think it's because cisco doesn't support static unicast arp entry:s pointing to more than one port. Try with multicast mac-address instead.
Here are a good link that explains this.
http://www.internetworkpro.org/wiki/Configuring_Cisco_to_work_with_a_Windows_NLB_Cluster
/Mikael
10-08-2009 10:47 AM
Hi, you know how solve this proble?
I have too, and can't find any issue.
Help please.
Thank you.
10-08-2009 11:03 AM
It has been explained above, you cannot have same unicast mac on more than one port.
10-08-2009 09:01 PM
thank you.
10-09-2009 12:17 AM
You are welcome, please remember to rate useful posts with the scrollbox below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide