cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
525
Views
0
Helpful
1
Replies

Cant Change Dialer Pool (2821 Version 12.4(13r)T)

brasso_42
Level 1
Level 1

Hi

I’m having an issue with one of my lines in an MLPPP bundle and need to separate it out for further testing.

To do this I’ve created another Dialer and re-assigned the atm interface (atm0/0/0) to it. Then I’ve done a shut and then a no shut a min or two later. To my surprise the debug ppp negotiation showed the user name from Dialer1 and then the line was back in my multi link bundle.

Can any one spot where I’m going wrong this is driving me mad.

My relevant Config is below:

interface ATM0/0/0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

pvc 0/38

  encapsulation aal5mux ppp dialer

  dialer pool-member 2

!

!

interface ATM0/1/0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

pvc 0/38

  encapsulation aal5mux ppp dialer

  dialer pool-member 1

!

!

interface Dialer0

ip address negotiated

ip virtual-reassembly

encapsulation ppp

dialer pool 1

keepalive 1

ppp reliable-link

ppp authentication chap callin

ppp chap hostname my_normal@user

ppp chap password 0 psw

ppp multilink

!

interface Dialer42

ip address negotiated

ip virtual-reassembly

encapsulation ppp

dialer pool 2

ppp reliable-link

ppp authentication chap callin

ppp chap hostname my_testing@user

ppp chap password 0 psw

!

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Update IOS, or zap configuration, reload and start again.

Review Cisco Networking for a $25 gift card