Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
456
Views
0
Helpful
1
Replies

CBWFQ with shaping

David Niemann
Level 3
Level 3

‎02-18-2013 12:34 PM - edited ‎03-04-2019 07:03 PM

I'm needing to create a QoS policy on a DS3 connection at a hub site.  There is a DR site with a DS3 and then several remote locations connected via MPLS.  I wan to limit the bandwidth that each remote site can use (close to their max limit) and apply QoS within each of those bandwidth allocations.  Can you tell me if this configuration looks right?

Labels:
143532-CBWFQConfig.txt.zip
0 Helpful
1 Reply 1

David Niemann
Level 3
Level 3

‎02-18-2013 03:48 PM

I've applied the policy, but am a little confused on the output of the show policy-map on the serial interface.  For the DR site I have shaping configured to average of 31457280 (30Mbps), but indicated bandwidth allocated to RealTime is only 4421kbps (4.3Mbps) and is suppose to be allocated 50% of the 30Mbps.  What's causing this? I've attached the show output

143543-show policy-map.txt.zip
0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card