06-05-2009 04:56 PM - edited 03-04-2019 05:00 AM
I have an interesting issue I have several routers 831 and 871 routes my issue is that I configure them and they work in my office; but when I take them to the location and plug them in to the cable modem or dsl modem it will get an ip address from the isp and it will hand out an ip address to the computer but the pc's cannot connect to the internet. Any ideas.
06-05-2009 05:12 PM
Just a guess here but shouldn't your access list 102 have the permit statement FIRST then the deny?
06-06-2009 09:49 AM
Tried that and it sill does not work.
06-06-2009 10:03 AM
You don't seem to have a NAT statement in your config ie. you have "ip nat inside" and "ip nat outside" under your interfaces but no nat statement.
Try adding this -
ip nat inside source list 102 interface eth1 overload
Jon
06-06-2009 02:28 PM
I tried adding that in and i also noticed a new issue the router is not getting a ip address from the cable modem and i have reset both. and i have added a replacement copy of the script with the updated information.
06-11-2009 12:16 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide