Routing

If I have an MFR0 bundle and I have a policy map on the major interface and a policy map on the subinterfaces does the policy on the subinterface override or is it a combination deal?

I want to do OSPF load balancing, but not working.i have 3 sites, Site A, Site B, Site C.All connected via mpls , and we running ospf with provider.I want to load balance traffic on Site C, means customer sitting on site C, and one request should go ...

Hello All:I'm not sure this is even a router issue but have a problem with a site to site tunnel created on our FW.The circuit in question delivered by ISP to our 3640. Router to FW vai FA0/1 which is assigned our global IP 66.52.5.xThe tunnel is set...

Hi,A query regarding HWIC-2FE.I have 1841 router. It already 2 integrated fastethernet ports. IF I add HWIC-2FE then how many usable Fastethernet ports will be available for me. Is it 4? I got an information that HWIC-2FE will only have one active Fa...

I'm new to GRE tunnels and I've some quick questions1)tunnel at one side stays up, unless the source interface defined under tunnel goes down?2)if marking(L3) is done at the edge there's no need for qos preclassify3)in a IPsec over GRE hub and spoke ...

Hi experts,I am trying to configure EIGRP in FRAME RELAY. I have 3 Routers (R1, R2, R3) where R1 is spoke - 192.168.1.1R2 is hub - 192.168.1.2R3 is hub - 192.168.1.3EIGRP Split Horizon is enabled in R1. I have configured EIGRP in all the routers. As ...

Hello!I have Cisco1801 connected to 2 ISPs. Each ISP connected with real IP address. Each WAN interface have associated VTI. Main role of Cisco1801 is IPSec hub for many ipsec clients to make secure link between subnets. Each ipsec client creates 2 ...

I am about to take over a network that is running a BGP with two ISPs. There is a single router that is connected to two service providers. Last month the primary ISP had some issues but the Internet did not fail over to the backup service provider. ...

Just a quick question. Is there any specific reason that you would choose to let the router handle NAY or your FW if given the choice.Pro's, Con's etcThanks

Configuring dynamic vpn tunnels, however this small network is using frame-relay with sub-interfaces. On the hub router, when configuring the tunnel source you can only enter a single interface, if I have 2 remotes, I have 2 sub interfaces, how do y...

I have configured this test config for learning NAT:on router. How I can test and understood work of it?Thank you!access-list 1 remark ACL Category=2access-list 1 permit 10.10.2.0 0.0.0.255interface FastEthernet0/1 ip nat outside exitinterface FastEt...

Hello Freinds, First, What is the exact difference between Broadcast & Multicast...please.Second,Kindly tell about the command use to enable the event logs(uptil latest time) on cisco devices i.e logs which are reflecting on "Sh Logg" output. Actua...

Hello,I've been trying to set up a small network with the RVS 4000 but no luck at the moment. Need urgent help.Set up is:Server: 192.168.100.1Server: 192.168.100.2Internet Connection: 192.168.100.3 with static IP 10.10.10.10RVS 4000: 192.168.100.4Des...

I am trying to choose a router for a 300 meg metro ethernet connection. Would a 3800 series router be sufficient or should I go up to a 7200 series router? I may need to run MPLS on this link in the future.