Circuit selection on Multilink PPP over ATM bundle.

[ghent]

Hi,

I have an issue with Multilink PPP over ATM.

I have two boxes, an 1841 and a 7206 which are connected by 2 different ATM links. Each link has 2 different PVCs, a vbr-rt PVC for VoIP and ubr PVC for Data.

I Also need to run Multilink PPP.

Now, this wouldn't have been a problem if I could run 2 Multilink PPPs between the same boxes, but since I can't I need to find a way to direct the voice traffic to the vbr-rt circuits while sending the data to the ubr circuits.

Anyone tried this or have an idea I might be able to use?

Regards,

Sigurbjartur

[pkhatri · Accepted solution]

Hi,

It is possible to run more than one multilink PPP session between the same two routers.

Here's a link that explains this:

http://www.cisco.com/en/US/partner/tech/tk713/tk507/technologies_configuration_example09186a0080093c1d.shtml

Hope that helps - pls do remember to rate posts that help.

Paresh

[ghent]

Hi,

Thank you for your response. The information in the link didn't quite solve my issue but it got me on the right track so I did manage to solve it. I found that it isn't neccesary to run ppp authentication, with the usernames, over the link but suffices to specify the chap hostname to change the endpoint identifier.

Regards,

Sigurbjartur