08-12-2015 04:58 AM - edited 03-05-2019 02:03 AM
08-12-2015 05:52 AM
It's listed on the same page: VIC2-2BRI-NT/TE
08-12-2015 05:37 AM
All supported modules are listed on the "Interfaces & Modules" page. And yes, the WIC-1B-S/T-V3 is supported.
08-12-2015 05:40 AM
Thanks for your reply.
What I need is a card that I can use for voice. I need to connect them to the PSTN using BRI/ISDN. Would this card work?
Thanks
08-12-2015 05:52 AM
It's listed on the same page: VIC2-2BRI-NT/TE
08-12-2015 07:45 AM
Thanks again Karsten,
Any tips with the config?
Te scenario is:
CISCO_CME---ROUTER_BRI -----to----- BT_TELECOM_PSTN
08-13-2015 11:29 AM
In my scenario, should I configure TE or NT, since I'm connecting to my PSTN?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: