Cisco 1941 Router

[spaseman.spiff]

I am new to the Network arena. My company purchased a Cisco 1941, and I need to configure it for one of our offices.

I have researched and done the basics, but now need assistance witht the rest of my configuration.

I have been given the following information:

216.7.133.242 - Your static IP

216.7.133.241 - the Gateway

255.255.255.252 - Subnet Mask

64.191.128.10 and 64.191.128.101 - DNS servers

Here's is my basic config info so far:

interface GigabitEthernet0/0

descrption router

ip address 216.7.133.242 255.255.255.252

duplex auto

speed auto

I still need to configure the gateway address, and the DNS entries.

Apologies for my ignorance.. :O)

Thank you!!

- Joey

[edondurguti · Accepted solution]

enter the clobal config from enable mode

conf t

ip route 0.0.0.0 0.0.0.0 216.7.133.241

ip name-server 64.191.128.10 64.191.128.101

end

wr

[spaseman.spiff]

Edon -

Thanks soooo much for the the assistance on this !!!

- Joey

[edondurguti]

No problem.

Please mark as correct answer, thank you

[johnlloyd_13]

hi joey,

further adding to edon's post, you should also configure the LAN interface and consider if the DHCP and NAT will be performed by this router.

int g0/1

ip address 192.168.1.254 255.255.255.0

ip nat in

int g0/0

ip nat out

access-list 1 permit 192.168.1.0 0.0.0.255

ip nat inside source list 1 interface g0/0 overload

ip dchp pool LAN

network 192.168.1.0 255.255.255.0

default-router 192.168.1.254

dns-server 8.8.8.8

[spaseman.spiff]

John -

Thanks for the assistance. You lost me with the 192.x.x.x address. I take it I replace the 192.x.x.x address with my IP_address?

Thanks.

- Joey

[johnlloyd_13]

hi joey,

the suggested 192.x.x.x is the private IP range for your LAN. that is, if you plan to use one though.

[spaseman.spiff]

D'oh !!!  Thanks.